Conversion from Ext3
Btrfs Conversion from Ext3 or Ext4
Btrfs has very few pieces of metadata that live in fixed locations, making it relatively easy to implement an in place conversion utility from other filesystems. Copy on write algorithms allow Btrfs to preserve an unmodified copy of the original FS, and allow administrator to undo the conversion, even after making changes in the resulting Btrfs filesystem.
The conversion program btrfs-convert uses libe2fs to read the Ext3/4 metadata, and uses the free blocks in the Ext3 filesystem to hold the new Btrfs. The basic conversion algorithm works like this:
- Duplicate the first 1MB of the device
- Duplicate directories and inodes, creating copies in Btrfs
- Take references on Ext3 file data blocks from the Btrfs files
This does create copies of all the Ext3 metadata, but the Btrfs files simply point to the same blocks used by the Ext3 files. This shares the bulk of the blocks in use between the two filesystems. Because Btrfs uses copy on write for all file modifications, the original Ext3 version of the file data blocks is preserved.
The first 1MB of the device is copied to an alternate location so that Btrfs metadata may be written there. Undoing the conversion simply involves restoring these blocks.
The result of the conversion looks something like this:
The conversion program creates a snapshot in Btrfs that references all of the blocks used by Ext3, allowing the administrator to control how long the original Ext3 filesystem is preserved. If the admin wishes to recover the space used by Ext3, the snapshot can be deleted and the conversion will be permanent.
Until the snapshot is deleted, only blocks that were marked as free in Ext3 are used to hold new Btrfs modifications. This means the conversion can be undone at any time, restoring the original Ext3 FS. The converter creates a sparse file to hold all of the references to the original Ext3 filesystem, and the offsets in this file correspond to offsets on the block device. This allows the admin to mount the image file via readonly loopback and see the original Ext3 filesystem and the converted Btrfs filesystem at the same time.
# Always run fsck first fsck.ext3 -f /dev/xxx # Convert from Ext3/4->Btrfs btrfs-convert /dev/xxx # Mount the resulting Btrfs filesystem mount -t btrfs /dev/xxx /btrfs # Mount the ext3/4 snapshot mount -t btrfs -o subvol=ext2_saved /dev/xxx /ext2_saved # Loopback mount the image file mount -t ext3 -o loop,ro /ext2_saved/image /ext3
In the example above, the files in /ext3 and in /btrfs will be identical. Any modifications made in /btrfs will not show up in /ext3. If you wish to roll back the conversion:
# Completely unmount the Btrfs filesystem umount /ext3 umount /ext2_saved umount /btrfs # roll back the conversion btrfs-convert -r /dev/xxx # use the original filesystem mount -t ext3 /dev/xxx /ext3
Or, if you wish to recover the space used by the original Ext3/4 FS and make the conversion permanent, simply delete /ext2_saved/image. Once the image is deleted, the disk will look something like this: