btrfs-check - check or repair an unmounted btrfs filesystem
btrfs check [options] <emphasis><device></emphasis>
The filesystem checker is used to verify structural integrity of a filesystem and attempt to repair it if requested. The filesystem must be unmounted.
By default, btrfs check will not modify the device but you can reaffirm that by the option --readonly.
btrfsck is an alias of btrfs check command and is now deprecated.
Warning: Do not use --repair unless you are adviced to by a developer, an experienced user or accept the fact that fsck cannot possibly fix all sorts of damage that could happen to a filesystem because of software and hardware bugs.
The structural integrity check verifies if internal filesystem objects or data structures satisfy the constraints, point to the right objects or are correctly connected together.
There are several cross checks that can detect wrong reference counts of shared extents, backrefrences, missing extents of inodes, directory and inode connectivity etc.
The amount of memory required can be high, depending on the size of the filesystem, smililarly the run time.
SAFE OR ADVISORY OPTIONS
use the first valid set of backup roots stored in the superblock
This can be combined with --super if some of the superblocks are damaged.
verify checksums of data blocks
This expects that the filesystem is otherwise OK, so this is basically and offline scrub but does not repair data from spare coipes.
- --chunk-root <emphasis><bytenr></emphasis>
use the given offset bytenr for the chunk tree root
- -E|--subvol-extents <emphasis><subvolid></emphasis>
show extent state for the given subvolume
indicate progress at various checking phases
verify qgroup accounting and compare against filesystem accounting
- -r|--tree-root <emphasis><bytenr></emphasis>
use the given offset bytenr for the tree root
(default) run in read-only mode, this option exists to calm potential panic when users are going to run the checker
- -s|--super <emphasis><superblock></emphasis>
use 'superblock’th superblock copy, valid values are 0, 1 or 2 if the respective superblock offset is within the device size
This can be used to use a different starting point if some of the primary superblock is damaged.
enable the repair mode and attempt to fix problems where possible
create a new checksum tree and recalculate checksums in all files
Note: Do not blindly use this option to fix checksum mismatch problems.
build the extent tree from scratch
Note: Do not use unless you know what you’re doing.
btrfs check returns a zero exit status if it succeeds. Non zero is returned in case of failure.
btrfs is part of btrfs-progs. Please refer to the btrfs wiki http://btrfs.wiki.kernel.org for further details.